[Mesa-users] Modifying Time Steps for WD Diffusion

TYLER THOMAS FREDRICK tfredrick at wisc.edu
Wed May 4 23:22:05 UTC 2022


Hi Morgan,

Could you send me those controls? I didn't think about using them outside of the diffusion test itself. I would like to play around with them, if possible.

-Tyler

Get Outlook for Android<https://aka.ms/AAb9ysg>
________________________________
From: Morgan Taylor <taylormorgan32 at gmail.com>
Sent: Wednesday, May 4, 2022 5:30:53 PM
To: TYLER THOMAS FREDRICK <tfredrick at wisc.edu>
Cc: mesa-users <mesa-users at lists.mesastar.org>
Subject: Re: [Mesa-users] Modifying Time Steps for WD Diffusion

Hi Tyler,

Have you tried using diffusion in your wd_builder work directory, so not in the diffusion test case?  I haven't tried the diffusion case before but I turned on diffusion with wd_builder and it worked ok for me (no crazy timesteps).  I can send the diffusion controls I used if you're interested. Then you can modify them according to the network you're using.

Morgan

On Wed, May 4, 2022 at 5:25 AM TYLER THOMAS FREDRICK via Mesa-users <mesa-users at lists.mesastar.org<mailto:mesa-users at lists.mesastar.org>> wrote:
Good morning all,

I an currently running mesa-r15140 with some wd models in the diffusion test case. I’ve noticed that the time step is a little too small for what I would like to run, and it takes a long time to reach the termination condition. I would like to increase the time step to shorten this process, but everything I’ve tried so far has not changed anything.

I’ve tried using force_timestep_min to force larger steps, but it did not work. I also tried messing with the following lines:

! Timestep controls to prevent steps that are difficult for diffusion.
diffusion_steps_limit = 10
diffusion_steps_hard_limit = 50
diffusion_iters_limit = 50
diffusion_iters_hard_limit = 100

! Solver controls.
! diffusion_use_isolve = .true.
! diffusion_rtol_for_isolve = 1d-4
! diffusion_atol_for_isolve = 1d-5
! diffusion_maxsteps_for_isolve = 1000
! diffusion_isolve_solver = 'ros2_solver'

I’ve tried adjusting the values above, as well as un-commenting the solver controls. Neither did anything as well. If you have worked with the diffusion case I know how to adjust the time steps, any help would be greatly appreciated. Thank you!

V/R,

Tyler
_______________________________________________
mesa-users at lists.mesastar.org<mailto:mesa-users at lists.mesastar.org>
https://lists.mesastar.org/mailman/listinfo/mesa-users

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.mesastar.org/pipermail/mesa-users/attachments/20220504/f14988b1/attachment.htm>


More information about the Mesa-users mailing list