[Mesa-users] MESA test suite 1M_pre_ms_to_wd

[Natalia Dunina-Barkovskaya]

Good morning! Have you tried Z=0.03? Maybe 0.04 is too much for the WD
evolution...

пт, 19 февр. 2021 г., 04:57 sinta ayu sakinah via Mesa-users <
mesa-users at lists.mesastar.org>:

> Dear Mesa Developer,
>
> Good morning
> My name is Sinta Ayu Sakinah, i am from Indonesia, I have some trouble
> when running mesa test suite 1M_pre_ms_to_wd, i want to change the
> metallicity to be higher than Z=0.02d0, I used Z=0.04d0, but it didn't end
> until the evolution reach white dwarf. and the reason it stops because
> stop because model_number >= max_model_number.
>
>
> this is the inlist_start
> &controls
>
>    ! run for a few models after create pre ms, then save starting.mod
>
>       use_gold_tolerances = .true.
>
>       ! check for retries and backups as part of test_suite
>          max_number_backups = 0
>          max_number_retries = 15
>          max_model_number = 200
>
>       ! stop when the luminosity has decreased to 10 Lsun
>       ! for a 1 Msun star, this is roughly the on birthline
>       log_L_lower_limit = 1
>
>       initial_mass = 1.0
>       initial_z = 0.04d0
>
>       use_Type2_opacities = .true.
>       Zbase = 0.04d0
>
>       varcontrol_target = 1d-3
>
>       photo_interval = 50
>       profile_interval = 50
>       history_interval = 10
>       terminal_interval = 10
>       write_header_frequency = 10
>
>       !photo_interval = 1
>       !profile_interval = 1
>       !terminal_interval = 1
>       !history_interval = 1
>
> i already changed the Z to 0.04d0 for inlist_to_end_agb and for
> inlist_to_wd too.
> but i only got the model stops until here (picture)
>
> do you have any suggestion?
> for the information: I trun MESA version 12778 linux ubuntu and using
> MESASDK
>
> thank you very much,
>
> best regards,
> sinta
>
>
> _______________________________________________
> mesa-users at lists.mesastar.org
> https://lists.mesastar.org/mailman/listinfo/mesa-users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.mesastar.org/pipermail/mesa-users/attachments/20210219/7e99c30f/attachment.htm>