[Mesa-users] MESA test suite 1M_pre_ms_to_wd

[sinta ayu sakinah]

Dear Mesa Developer,

Good morning
My name is Sinta Ayu Sakinah, i am from Indonesia, I have some trouble when
running mesa test suite 1M_pre_ms_to_wd, i want to change the metallicity
to be higher than Z=0.02d0, I used Z=0.04d0, but it didn't end until the
evolution reach white dwarf. and the reason it stops because
stop because model_number >= max_model_number.


this is the inlist_start
&controls

   ! run for a few models after create pre ms, then save starting.mod

      use_gold_tolerances = .true.

      ! check for retries and backups as part of test_suite
         max_number_backups = 0
         max_number_retries = 15
         max_model_number = 200

      ! stop when the luminosity has decreased to 10 Lsun
      ! for a 1 Msun star, this is roughly the on birthline
      log_L_lower_limit = 1

      initial_mass = 1.0
      initial_z = 0.04d0

      use_Type2_opacities = .true.
      Zbase = 0.04d0

      varcontrol_target = 1d-3

      photo_interval = 50
      profile_interval = 50
      history_interval = 10
      terminal_interval = 10
      write_header_frequency = 10

      !photo_interval = 1
      !profile_interval = 1
      !terminal_interval = 1
      !history_interval = 1

i already changed the Z to 0.04d0 for inlist_to_end_agb and for
inlist_to_wd too.
but i only got the model stops until here (picture)

do you have any suggestion?
for the information: I trun MESA version 12778 linux ubuntu and using
MESASDK

thank you very much,

best regards,
sinta
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.mesastar.org/pipermail/mesa-users/attachments/20210219/1c384531/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: grid6_006500.png
Type: image/png
Size: 16449 bytes
Desc: not available
URL: <https://lists.mesastar.org/pipermail/mesa-users/attachments/20210219/1c384531/attachment.png>