[mesa-users] Kjeldsen correction in astero module

[Dennis Stello]

Hi Santiago,

It sounds to me that what you are looking for is in the simplex results 
file....did you you look there?

Cheers
Dennis/

-------
DENNIS STELLO | Senior Lecturer
School of Physics A28 | Faculty of Science

THE UNIVERSITY OF SYDNEY
Rm225, K90 | The University of Sydney | NSW | 2006
T +61 2 9036 5108  | F +61 2 9351 7726
E stello at physics.usyd.edu.au  | W http://www.physics.usyd.edu.au/~stello/


On Sat, 14 Feb 2015, Santiago Andres Triana wrote:

> Hi MESA users,
>
> Playing around with the astero module and simplex, I noticed that the
> frequencies, as reported in the sample_#.data files, are not
> corrected. They seem to be the raw, uncorrected  frequencies from gyre
> although I have specified the 'kjeldsen' method in
> inlist_astero_search_controls.
>
> The inlist is attached. The relevant snippet is this:
>
>    ! surface corrections
>      correction_scheme = 'kjeldsen' ! options are
>         ! 'kjeldsen'   Correction of Kjeldsen et al. (2008)
>         ! 'cubic'      Cubic correction of Ball & Gizon (2014, eqn 3)
>         ! 'combined'   Combined correction of Ball & Gizon (2014, eq 4)
>         ! ''           no corrections
>      correction_factor = 1
>         ! use this fraction of the correction; set to 0 to skip doing
> corrections.
>      l0_n_obs(:) = -1 ! the observed radial orders (ignored if < 0)
>         ! the observed radial orders are used in calculating surface
> corrections
>         ! if <= 0, use default calculation for radial orders
>      correction_b = 4.25d0
>
>      save_next_best_at_higher_frequency = .true.
>      save_next_best_at_lower_frequency = .true.
>
>
> I'm convinced that I'm doing something silly somewhere but cannot
> figure out where... any hints or comments are very much appreciated.
> Many thanks in advance!
>
> Cheers,
>
> Santiago
>